Roofing Steps Installation

Most metal shingles will be attached to the roof using metal shingle.

Roofing steps installation.

These pieces act as a weather proofing and protective barrier between your house and the elements helping keep water and cold temperatures out. Metal step flashing pieces. Start by laying asphalt felt or other underlayment over the roof. It stops water from getting.

Install a drip edge around the perimeter of the roof. Ice and water shield installation next step is installing ice and water shield which is a special type of roofing. Make sure the underlayment lies smooth before you nail the top edge. Stick on the underlayment.

When installing on metal roofing you seal under the flashing using a roofing cement and then fasten the flashing right over top of the metal roofing using rubber washer roofing screws just as you did with the roofing itself. In order to accomplish this staggering of gaps cut. Install shingles from the lower left corner working to the right and also working up the roof slope. Use sticky back ice and water shield as underlayment where ice dams or leaf and twig dams are likely to build up and at.

Work up from the initial row starting at the lower corner in a diagonal pattern staggering the shingles to prevent gaps. Imbed each step flashing in a 75 mm 3 wide application of asphaltic plastic cement and nail in place. Project step by step 15 roll out the self stick underlayment. Measure the roof area you will need to order enough metal material to cover the entire roof and this process starts with measuring the full size of your roof in square feet.

Using your staple gun secure the felt to the roof. Nail metal flashing called drip edge along the bottom edge of the roof deck near the gutters. The following 8 instruction steps will guide you through the installation of a metal roof. Install the starter strip which is just a backing for the first visible row of shingles.

Protect the roof against ice dams and windblown rain with self stick ice and water. Peel off the bottom backing. 4 preparing the roof surface for shingles drip edge installation after wood decking is prepared we install drip edge at all edges of the roof. There are two simple rules to follow.

Overlap each row at least 3 to 4 inches. Cut the sections of flashing with tin snips as needed and nail. Lay the starter row of metal shingles at the drip edge and affix to the roof with metal roofing nails. Then pull off the.