Tack Down Carpet

Each tack strip is approximately 4 feet long.

Tack down carpet.

Only remove the ones that were exposed from the carpet pull up inspection. The carpet tack should grip the edges of the carpet through the carpet backing. Wear protective gloves since the tack strips are filled with sharp points. The installation process is designed to hold the carpet in place for decades making it difficult to get up without the right equipment.

The tacks will grip the backing and hold the carpet in place. Nail the carpet tack strip to the floor using a hammer. Getting rid of it can be simple with the help of an experienced removal service equipped with specialized machinery and skill. Step 7 press forward on the knee portion of the tool to stretch the carpet and use a putty knife to tuck the edge of the carpet into the tack strip down in the floor.

The metal spiked head should face the doorway and the rubber pad should be near your knee. Press down on the carpet firmly without using a hammer so the tacks don t break or bend before they get hold of the carpet. Use the carpet kicker and stretch the carpet over the tacks and past the tack strip by 1 4 inch. Use a scrap board to prevent damage to the baseboard.

Then take your seam iron and run it across the tape. Lay two pieces of carpet directly up against one another. Tackless strips have at least three nails that run opposite the tacks. It s easy to unravel the fibers.

Then put the seam tape under the two edges. Push the lever down to stretch the carpet taut. Cut the carpet with a slotted blade knife so that it is even with the edge of the tile. This will melt the tape and make it hold the two pieces of carpet together.

Reach in front of the power stretcher to hook the carpet onto the tack strip. Step 5 tuck the end of the carpet into the gap between the tack strip and the tile by using a stair tool or a putty knife. Continue along the wall then trim excess with the wall trimmer and tuck the edge underneath the baseboard. If you have tack down carpet in your home it can be hard to remove.

Position a carpet kicker tool 3 inches away from the end of the carpet in the doorway. Once the carpet is rolled out and installed it has to be tacked down. Lift one corner of the carpet with a pair of pliers and gently tease it free of the tack strip photo 1.